smartctl 7.3 2022-02-28 r5338 [x86_64-linux-5.19.7-arch1-1] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate Mobile HDD Device Model: ST1000LM035-1RK172 Serial Number: WDE6XKP5 LU WWN Device Id: 5 000c50 0a8d42068 Firmware Version: LCM2 User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database 7.3/5319 ATA Version is: ACS-3 T13/2161-D revision 3b SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Sat Dec 10 15:41:20 2022 UTC SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x71) SMART execute Offline immediate. No Auto Offline data collection support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 165) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x3035) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 038 038 034 Pre-fail Always - 4750517 3 Spin_Up_Time 0x0003 099 099 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 090 090 020 Old_age Always - 10837 5 Reallocated_Sector_Ct 0x0033 069 069 036 Pre-fail Always - 188 7 Seek_Error_Rate 0x000f 084 060 045 Pre-fail Always - 13639300061 9 Power_On_Hours 0x0032 079 079 000 Old_age Always - 18780 (48 11 0) 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 096 096 020 Old_age Always - 4253 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 057 057 000 Old_age Always - 43 188 Command_Timeout 0x0032 091 091 000 Old_age Always - 60130984007 189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0 190 Airflow_Temperature_Cel 0x0022 075 052 040 Old_age Always - 25 (Min/Max 22/25) 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 157 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 79 193 Load_Cycle_Count 0x0032 001 001 000 Old_age Always - 214074 194 Temperature_Celsius 0x0022 025 048 000 Old_age Always - 25 (0 4 0 0 0) 196 Reallocated_Event_Count 0x0032 069 069 000 Old_age Always - 188 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 16 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 16 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x000f 080 080 030 Pre-fail Always - 18277 (129 218 0) 254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0 SMART Error Log Version: 1 ATA Error Count: 43 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 43 occurred at disk power-on lifetime: 18779 hours (782 days + 11 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 f8 ff ff ff ef 00 00:52:16.734 READ DMA EXT ef 10 03 00 00 00 a0 00 00:52:16.711 SET FEATURES [Enable SATA feature] ec 00 00 00 00 00 a0 00 00:52:16.708 IDENTIFY DEVICE ef 03 46 00 00 00 a0 00 00:52:16.694 SET FEATURES [Set transfer mode] ec 00 00 00 00 00 a0 00 00:52:16.692 IDENTIFY DEVICE Error 42 occurred at disk power-on lifetime: 18779 hours (782 days + 11 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 08 ff ff ff ef 00 00:52:11.073 READ DMA EXT ec 00 01 00 00 00 00 00 00:52:11.071 IDENTIFY DEVICE 25 00 f8 ff ff ff ef 00 00:52:08.332 READ DMA EXT 25 00 08 ff ff ff ef 00 00:52:08.274 READ DMA EXT e5 00 00 00 00 00 00 00 00:52:05.692 CHECK POWER MODE Error 41 occurred at disk power-on lifetime: 18777 hours (782 days + 9 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 c0 ff ff ff ef 00 00:50:09.683 READ DMA EXT ea 00 00 00 00 00 a0 00 00:50:09.681 FLUSH CACHE EXT ef 10 03 00 00 00 a0 00 00:50:09.671 SET FEATURES [Enable SATA feature] ef 10 02 00 00 00 a0 00 00:50:09.662 SET FEATURES [Enable SATA feature] 27 00 00 00 00 00 e0 00 00:50:09.635 READ NATIVE MAX ADDRESS EXT [OBS-ACS-3] Error 40 occurred at disk power-on lifetime: 18777 hours (782 days + 9 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 38 ff ff ff ef 00 00:50:06.439 READ DMA EXT ef 10 03 00 00 00 a0 00 00:50:06.428 SET FEATURES [Enable SATA feature] ef 10 02 00 00 00 a0 00 00:50:06.419 SET FEATURES [Enable SATA feature] 27 00 00 00 00 00 e0 00 00:50:06.392 READ NATIVE MAX ADDRESS EXT [OBS-ACS-3] ec 00 00 00 00 00 a0 00 00:50:06.390 IDENTIFY DEVICE Error 39 occurred at disk power-on lifetime: 18777 hours (782 days + 9 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 08 ff ff ff ef 00 00:50:00.557 READ DMA EXT 25 00 f8 ff ff ff ef 00 00:49:57.774 READ DMA EXT 25 00 08 ff ff ff ef 00 00:49:57.764 READ DMA EXT 25 00 08 ff ff ff ef 00 00:49:55.079 READ DMA EXT 25 00 08 ff ff ff ef 00 00:49:52.561 READ DMA EXT SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Conveyance offline Aborted by host 90% 4364 - # 2 Vendor (0x50) Aborted by host 90% 4363 - # 3 Short offline Aborted by host 90% 4363 - # 4 Vendor (0x50) Aborted by host 90% 877 - # 5 Short offline Completed without error 00% 877 - # 6 Vendor (0x50) Completed without error 00% 829 - # 7 Short offline Completed without error 00% 829 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.